How to Replace Bathtub Faucet? [Easy Installation Guide]

How to replace bathtub faucets

Decent Home Decor is reader-supported. When you buy through links on our site, we may earn an affiliate commission. However, our editorial content is not influenced by the commission. Learn More.

Replacing a bathtub faucet will give an immediate fresh and new look to your tub. Interestingly, it is one of the easiest of plumbing home jobs. The process of removing the old one and installing the new faucet will take not more than an hour, so it’s going to be a simple task for you.

How to replace bathtub faucets

Tools You Need

  • Water pump pliers.
  • A sturdy screwdriver.
  • Teflon tape.
  • A set of hex wrenches.

4 Steps to Give a New Look of Your Tub.

Step 1: Remove the Old Faucet

The process of replacing your Bathtub faucet starts with removing the old faucet. Take a small screwdriver or hex wrench to loosen the screw located below the faucet. If there is no set screw, take a wooden hammer or screwdriver and place the handle of this tool to fit inside the opening of the spout. Now rotate it counterclockwise smoothly to loosen it and remove the faucet by hand. Sometimes, you may directly unscrew the faucet by hand if it is not placed too tightly.

Step 2: Purchase the New Faucet

The second step is to buy the new faucet for your bathtub. Don’t forget to take the old one with you while you go to a home improvement store. Matching with the size and type of old faucet now you can purchase the new one. Make sure you are replacing screw-on faucet by a screw-on faucet and slip-on faucet by a slip-on faucet. You can choose any of the new faucets from the vast amount of style and design. The important issue is the length of the connection pipe protruding from the wall. If the same size of faucet is not available for instance, you can buy a faucet nipple to help you to fit with the pipe and faucet.

You may love to read this as well! > 10 Best Bathroom Faucets Review

Step 3: Installing the Spout Nipple

The stage of installing the new faucet starts with installing the spout nipple. First, remove the old spout nipple. Use a pipe wrench or basin wrench to remove the spout nipple. You may need an internal pipe wrench if the bonnet nut is tightly recessed.

Now, wrap the Teflon tape around the end of the threaded pipe and screw the new tub spout on clockwise by hand until it is tight and pointed down.

Step 4: Installing the Faucet

Start with taping around the thread on the spout nipple and then twist the faucet onto the nipple in a clockwise motion. Use water pump pliers to tighten it. Note that the jaws of the pliers are covered with tape to prevent scratching the faucet. Be careful that you don’t over-tighten.

If it’s a set screw faucet then simply slip it into place and tighten the set screw underneath.

Finally, check once by switching on the tub and be sure the installation is done successfully.

Watch this: How to Replace a Bathtub Spout

Spread the love
Scroll to Top